Enter subhead content here

MSDS      DELETE GRAFFITI REMOVER

COMPLIES WITH OSHA’S HAZARD COMMUNICATION STANDARD (29 CFR 1910.1200)

SECTION I · PRODUCT IDENTIFICATION

Product Name: Delete Graffiti Remover Formula: Proprietary HMIS Rating (Based on Aerosol Conc.):

Proprietary HMIS Rating (Based on Aerosol Conc.):

Product Number: 175 Date Prepared: 11/15/07 0-Minimal 1- Slight 2- Moderate

175 Date Prepared: 11/15/07 0-Minimal 1- Slight 2- Moderate

Product Type: AEROSOL Emergency Phone: (800) 535-5053 3-Serious 4- Extreme

AEROSOL Emergency Phone: (800) 535-5053 3-Serious 4- Extreme

Supplier's Name: Winner Industrial Supply Information Phone: (877) 597-6261 HEALTH1 FIRE: 3 REACTIVITY: 0

(877) 597-6261 HEALTH1 FIRE: 3 REACTIVITY: 0

Supplier's Address: 2375 East Tropicana Ave. #768, Las Vegas, NV 89119 Personal Protection: B

2375 East Tropicana Ave. #768, Las Vegas, NV 89119 Personal Protection: B

D.O.T. Hazard Class: CONSUMER COMMODITY · ORM-D

CONSUMER COMMODITY · ORM-D

SECTION II · INGREDIENTS

CHEMICAL NAME CAS # %WT 313/Chem Skin Carcinogen PEL TWA/TLV

Toluene 108-88-3 50-60 YES NO NO 100 ppm 100 ppm

Diacetone Alcohol 123-42-2 01-10 NO NO NO 50 ppm 50 ppm

Isopropyl Alcohol 67-63-0 01-10 NO NO NO 400 ppm 400 ppm

Liquefied Petroleum Gas 68476-86-8 15-25 NO NO NO 1000 ppm 1000 ppm

SECTION III · PHYSICAL DATA

Data Below Based On Aerosol Concentrate Only:

Boiling Point: ~194°F

pH: N/A Vapor Density(Air=1): >1

Solubility In Water: Emulsifies Specific Gravity (H2O=1)@75°F: 0.913

Appearance/Odor: Creamy White Jel, Mild Odor

Appearance/Odor: Creamy White Jel, Mild Odor

 

Appearance/Odor: Creamy White Jel, Mild Odor

2O=1)@75°F: 0.913

Appearance/Odor: Creamy White Jel, Mild Odor

Data Below Based On Total Contents:

Vapor Pressure of can (psig @70°F): 45

Total VOC%: ~ 84%

SECTION IV · FIRE AND EXPLOSION DATA

Flash Point (of Concentrate Only): 54°F (T.O.C.) Flammability (as per USA Flame Projection Test): Extremely Flammable Spray

(of Concentrate Only): 54°F (T.O.C.) Flammability (as per USA Flame Projection Test): Extremely Flammable Spray

Extinguishing Media: Foam, CO2, Dry Media

Foam, CO2, Dry Media

Special Fire Fighting Procedures: Wear self-contained breathing apparatus and protective clothing. Cool fire exposed containers to prevent rupturing.

Wear self-contained breathing apparatus and protective clothing. Cool fire exposed containers to prevent rupturing.

Unusual Fire and Explosion Hazards: Exposure to temperature above 120° F may cause bursting.

Exposure to temperature above 120° F may cause bursting.

SECTION V · REACTIVITY DATA

Stability: Material Stable. Hazardous Polymerization: Will not Occur.

Material Stable. Hazardous Polymerization: Will not Occur.

Incompatibility: Avoid contact with strong oxidizing agents.

Avoid contact with strong oxidizing agents.

Hazardous Decomposition Products: Carbon Dioxide, Carbon Monoxides.

Carbon Dioxide, Carbon Monoxides.

SECTION VI · STORAGE AND HANDLING

KEEP OUT OF REACH OF CHILDREN.

For Industrial and Institutional use only.

Store in a cool, dry area away from heat or open flame.

Do not store at temperatures above 120° F. NFPA Code 30B Rating: Level 2 Aerosol.

NFPA Code 30B Rating: Level 2 Aerosol.

SECTION VII · HEALTH AND FIRST AID

PRIMARY ROUTES OF ENTRY & EFFECTS OF OVER EXPOSURE:

Eyes: May cause irritation. Symptoms include stinging, tearing, redness, and swelling of eyes.

May cause irritation. Symptoms include stinging, tearing, redness, and swelling of eyes.

Skin: Frequent or prolonged contact may cause irritation. May aggravate existing skin conditions.

Frequent or prolonged contact may cause irritation. May aggravate existing skin conditions.

Inhalation: Inhalation of mist can cause irritation of nasal and respiratory passages. Abusive or excessive inhalation may cause irritation to the upper respiratory tract,

dizziness, nausea and other central nervous system effects.

dizziness, nausea and other central nervous system effects.

 

dizziness, nausea and other central nervous system effects.

Inhalation of mist can cause irritation of nasal and respiratory passages. Abusive or excessive inhalation may cause irritation to the upper respiratory tract,

dizziness, nausea and other central nervous system effects.

Ingestion: Can cause gastrointestinal irritation, nausea, vomiting and diarrhea. Aspiration of material into the lungs can cause lung inflammation and other lung injury..

Can cause gastrointestinal irritation, nausea, vomiting and diarrhea. Aspiration of material into the lungs can cause lung inflammation and other lung injury..

FIRST AID PROCEDURES:

Eyes: Flush with large amounts of cool running water for at least 15 minutes while holding upper and lower lids open. If irritation persists get medical attention immediately.

Flush with large amounts of cool running water for at least 15 minutes while holding upper and lower lids open. If irritation persists get medical attention immediately.

Skin: Wash with soap and water. If irritation persists seek medical attention.

Wash with soap and water. If irritation persists seek medical attention.

Inhalation: Remove to fresh air. Seek medical attention immediately. If breathing stops give artificial respiration.

Remove to fresh air. Seek medical attention immediately. If breathing stops give artificial respiration.

Ingestion: Do not induce vomiting. Seek medical attention immediately.

Do not induce vomiting. Seek medical attention immediately.

SECTION VIII · SPECIAL PROTECTION DATA

Respiratory Protection: None needed for proper use in accordance with label directions.

None needed for proper use in accordance with label directions.

Ventilation: Provide local exhaust to keep air concentration of ingredients listed in Section II below acceptable limits.

Provide local exhaust to keep air concentration of ingredients listed in Section II below acceptable limits.

Protective Gloves: Use chemical resistant gloves if hand contact will be made.

Use chemical resistant gloves if hand contact will be made.

Eye Protection: Always wear safety glasses or chemical proof goggles when working with chemicals.

Always wear safety glasses or chemical proof goggles when working with chemicals.

SECTION IX · SPILL OR LEAK PROTECTION

STEPS TO BE TAKEN IN CASE OF SPILL OR LEAK: Allow propellant to evaporate. Maintain local exhaust and adequate ventilation. No smoking. Keep sparks, heat

sources and open flame far away from spill or leak. Cover with absorbent material and sweep up. Wash area to prevent slipping. Dispose of soaked absorbent material in

accordance with Federal, State and local laws.

sources and open flame far away from spill or leak. Cover with absorbent material and sweep up. Wash area to prevent slipping. Dispose of soaked absorbent material in

accordance with Federal, State and local laws.

 

sources and open flame far away from spill or leak. Cover with absorbent material and sweep up. Wash area to prevent slipping. Dispose of soaked absorbent material in

accordance with Federal, State and local laws.

Allow propellant to evaporate. Maintain local exhaust and adequate ventilation. No smoking. Keep sparks, heat

sources and open flame far away from spill or leak. Cover with absorbent material and sweep up. Wash area to prevent slipping. Dispose of soaked absorbent material in

accordance with Federal, State and local laws.

WASTE DISPOSAL METHOD: Aerosol cans, when emptied and depressurized through normal use, pose no disposal hazard and should be recycled. Consult Federal, State

and local authorities for approved procedures.

and local authorities for approved procedures.

 

and local authorities for approved procedures.

Aerosol cans, when emptied and depressurized through normal use, pose no disposal hazard and should be recycled. Consult Federal, State

and local authorities for approved procedures.

N/A= NOT APPLICABLE · N/E=NOT ESTABLISHED · N/D=NOT DETERMINED · <=LESS THAN · >=MORE THAN

NOTICE: The information contained on this Material Safety Data Sheet is considered accurate as of the date of publication. It is not necessarily all inclusive nor fully adequate in every circumstance.

The suggestions should not be confused with, nor followed in violation of applicable laws, regulations, rules or insurance requirements. No warranty, express or implied, of merchantability, fitness,

accuracy of data, or the results to be obtained from the use thereof is made. The vendor assumes no responsibility for injury or damages resulting from the inappropriate use of this product.

The suggestions should not be confused with, nor followed in violation of applicable laws, regulations, rules or insurance requirements. No warranty, express or implied, of merchantability, fitness,

accuracy of data, or the results to be obtained from the use thereof is made. The vendor assumes no responsibility for injury or damages resulting from the inappropriate use of this product.

 

The suggestions should not be confused with, nor followed in violation of applicable laws, regulations, rules or insurance requirements. No warranty, express or implied, of merchantability, fitness,

accuracy of data, or the results to be obtained from the use thereof is made. The vendor assumes no responsibility for injury or damages resulting from the inappropriate use of this product.

The information contained on this Material Safety Data Sheet is considered accurate as of the date of publication. It is not necessarily all inclusive nor fully adequate in every circumstance.

The suggestions should not be confused with, nor followed in violation of applicable laws, regulations, rules or insurance requirements. No warranty, express or implied, of merchantability, fitness,

accuracy of data, or the results to be obtained from the use thereof is made. The vendor assumes no responsibility for injury or damages resulting from the inappropriate use of this product.

Edit Text

 

Enter content here

Enter content here

Enter content here

Enter supporting content here