Material Safety Data Sheet
Moly Lube
PAGE
1
of 3
Winner Industrial supply, Inc.
154-a
west foothill blvd
149
Upland,ca. 91786
Emergency Phone Number: (877-597-6161
DATE
PREPARED:
July 12 2013
REVISION
DATE
:
04/24/2013
CHEM
-
TEL
:
800-225-3924
PRODUCT
NUMBER
:
581ae
SECTION I
-
IDENTIFICATION PRODUCT NAME:
Moly
Lube Chain and Cable Lubricant
PRODUCT USE
:
Lubricant wth Moly
SECTION II
–
COMPOSITION/
HAZARDOUS INGREDIENTS
HAZARDOUS
INGREDIENT
CAS NUMBER
OSHA PEL
ACGIH TLV
Hydrotreated Heavy Naphthenic Petroleum Distillate
64742
-
52
-
5
5 mg/m3
5 mg/m3
Propane/N
-
Butane
68476
-
86
-
8
N/A
1000 ppm
SECTION III
–
HAZARDS IDENTIFICATION
EMERGENCY
OVERVIEW:
Flammable aerosol, Contents under pressure exposure to high temperatures above
120F can cause
bursting. Keep away from heat, sparks, or open flame.
ROUTES OF ENTRY
:
Eyes,
Ingestion, Inhalation, Skin
EYES:
Causes mild irritation
INGESTION:
May
cause gastrointestinal irritation, nausea, diarrhea, vomiting. harmful if swallowed.
INHALATION:
May cause irritation to the respiratory tract.
SKIN:
May cause irritation, local
ized defatting. Redness and itching or burning
sensation may indicate excessive exposure.
MEDICAL CONDITION AGGRAVATED:
Preexisting eye, skin, and respiratory disorders may be aggravated by exposure to this
product
CHRONIC HEALTH HAZARDS:
None
CARCINOGENICITY:
OSHA
:
No
ACGIH
:
No
NTP
:
No
IARC
:
No
OTHER:
N/A
SECTION IV
-
FIRST AID MEASURES
EYES:
Immediately flush with water for 15
-
20 minutes while holding eyelids open. Seek medical attention if irritation persists.
INGESTION
:
Do not induce
vomiting unless directed by medical authority. Immediately rinse mouth with water. Seek immediate
medical
attention.
INHALATION
:
Move
to fresh air. If breathing difficulty persists, seek medical attention.
SKIN:
Immediately wash with soap and w
ater for 15 minutes. Remove
contaminated clothing and shoes immediately. Seek immediate
medical attention. Do
not use solvents to remove oil.
NOTE TO PHYSICIAN:
Do
not induce vomiting use gastric lavage only. Aspiration of petroleum distillates associated with vomiting
may cause pulmonary irritation and pneumonitis. If aspiration is suspected, respiratory effects should
be evaluated. Suspicious
skin lesion should be excised and examined histologically.
SECTION V
–
FIRE
-
FIGHTING MEASURES
FLASH
POINT:
> 200°F
FLAMMABLE LIMITS IN AIR,
(% BY VOLUME) UPPER
:
N/A
LOWER
:
N/A
EXTINGUISHING MEDIA:
Dry chemical, foam, or Carbon Dioxide (CO2).
SPECIAL FIRE FIGHTING PROCEDURES:
Wear NIOSH approved Self
Contained Breathing Apparatus
with a full face piece operated in a positive pressure demand
mode with full body protective clothing when fighting fires. Avoid contact with skin and
breathing
smoke, fumes, and decomposition products. Cool fire exposed containers with water fog to prevent bursting.
UNUSUAL FIRE AND EXPLOSION HAZARDS:
None known
HAZARDOUS COMBUSTION PRODUCTS:
Oxides of carbon
Material Safety Data Sheet
Moly Lube
PAGE
2
of
3
SECTION VI
–
ACCIDENTAL RELEASE
MEASURES
SPILL:
Absorb with noncombustible material like
vermiculite, sand or earth and rinse with small amount of soapy water. Do not allow to
drain
into sewers or storm drains. Dispose of in accordance with local, state and federal regulations.
WASTE
DISPOSAL:
Dispose of in accordance with federal, state, and local regulations. Best method
is to recycle or reuse for intended purpose. Consult local authorities for disposal in public sewer. Do not dispose of into
storm drain, stream, river or to ground.
Rinse container thoroughly before discarding
in trash.
RCRA STATUS:
Product should be fully
characterized prior to disposal (40 CFR 261).
SECTION VII
–
HANDLING AND STORAGE
HANDLING AND STORAGE:
Store
in a cool, dry area away from ignition sources. Do not reuse container. Offer empty container for
recycling
with an authorized drum recycling company. Keep
away from children.
OTHER
PRECAUTIONS:
None
SECTION VIII
–
EXPOSURE CONTROLS/PERSONAL PROTECTION
ENGINEERING CONTROLS /
VENTILATION:
General ventilation adequate.
RESPIRATORY PROTECTION:
Not required with normal use. Wear NIOSH/MSHA approved respiratory protection if exposure limits are
exceeded.
PROTECTIVE CLOTHING:
Safety glasses
and chemical resistant gloves are recommended.
ADDITIONAL MEASURES:
Wash
hands and clothing in contact with product after use
SECTION I
X
-
PHYSICAL
AND CHEMICAL
PROPERTIES
APPEARANCE:
Gray
-
Black
ODOR:
Oily odor
PHYSICAL STATE:
Liquid
BOILING POINT:
>390°F
FREEZING
POINT:
Not Tested
VAPOR PRESSURE (mm Hg):
<0.01 @ 77°F (25°C)
VAPOR DENSITY (AIR=1):
>
1
EVAPORATION RATE:
N/A
SPECIFIC
GRAVITY (H2O=1):
0.92 @ 77° F (25° C)
pH:
7.0
SOLIDS (%):
Not tested
SOLUBILITY IN WATER:
0%
VOLATILITY
INCLUDING WATER (%):
N/A
VOLATILE ORGANIC
COMPOUNDS (VOC):
0%
DIELECTRIC STRENGTH
(Volts):
N/A
SECTION X
–
STABILITY AND REACTIVITY DATA
CHEMICAL STABILITY:
Stable
CONDITIONS TO AVOID:
Excessive heat, open flames, sparks
INCOMPATIBILITY:
Strong oxidizing agents.
HAZARDOUS DECOMPOSITION OR BY
-
PRODUCT:
Oxides of Carbon, hydrocarbons
HAZARDOUS POLYMERIZATION:
Will not occur
SECTION XI
–
TOXICOLOGICAL IN
FORMATION
TO
X
ICOLOGICAL INFORMATION
:
N/A
