Material Safety data Sheet
Product Name: Food Grade Grease
Date Prepared: 1/9/2009
Product Type: AEROSOL Date Printed: 1/11/2009
Formula: Proprietary 0
Winner Industrial Chemical
3246 North E Street
San Bernardino,ca. 92405
Ship Description: Consumer Commodity, ORM-D B
CHEMICAL NAME CAS # %WT 313/Chem
Skin Carcinogen PEL TLV-TWA
Zinc Oxide 1314-13-2 1 - 10 YES NO NO N/E N/E
Petroleum Gas 68476-86-8 60 - 80 NO NO NO 1000 ppm 1000 ppm
Boiling Point: N/D Specific Gravity (H2O=1)@70°F: 0.9
N/A Solubility In Water: slight
Appearance/Odor: White Cream, Slight Odor Vapor Density(Air=1): >1
%: 70.00% Vapor Pressure (can; psig @72°F): 45 psig
Flash Point (Conc.): None Flammability (as per CSMA Flame Projection
Test): Extremely-Flammable Spray
Extinguishing Media: Foam, CO2, Dry Media
Stability: Material Stable. Hazardous
Polymerization: Will not Occur.KEEP OUT OF REACH OF CHILDREN. NFPA Code 30B
Rating: Level 2 Aerosol.
For Water Districts ,food
facilities, Industrial and Institutional use only.
Store in a cool, dry area away from heat or open flame.
not store at temperatures above 120° F.
PRIMARY ROUTES OF ENTRY &
EFFECTS OF OVER EXPOSURE:
FIRST AID PROCEDURES:
MATERIAL SAFETY DATA SHEET
WITH OSHA’S HAZARD COMMUNICATION STANDARD (29 CFR 1910.1200)
I · PRODUCT IDENTIFICATION
HMIS Rating (Based on Aerosol Conc.):
SECTION II · INGREDIENTS
SECTION III · PHYSICAL DATA
SECTION IV ·
FIRE AND EXPLOSION DATA
Special Fire Fighting Procedures: Wear self-contained
breathing apparatus and protective clothing. Cool fire exposed containers to prevent rupturing.
Unusual Fire and Explosion
Hazards: Exposure to temperature above 120° F may cause bursting.
V · REACTIVITY DATA
Incompatibility: Avoid contact with strong oxidizing
Hazardous Decomposition Products: Carbon Dioxide, Carbon Monoxide.
VI · STORAGE AND HANDLING
SECTION VII · HEALTH AND FIRST AID
May cause slight irritation but does not injure eye tissue.
Skin: Frequent or prolonged contact may cause irritation.
May aggravate existing skin conditions.
Inhalation: Inhalation of mist can cause irritation of nasal and respiratory
passages. Abusive or excessive inhalation may cause irritation to the upper respiratory tract, dizziness, nausea
other central nervous system effects.
Ingestion: Can cause gastrointestinal irritation, nausea, vomiting and diarrhea.
Aspiration of material into the lungs can cause chemical pneumonitis. Minimal toxicity.
Ventilation: Provide local exhaust
to keep air concentration of ingredients listed in Section II below acceptable limits.
Protective Gloves: Use chemical
resistant gloves if hand contact will be made.
Eyes: Flush with large amounts of cool running water for at least 15
minutes while holding upper and lower lids open. If irritation persists get medical attention immediately.
with soap and water. If irritation persists seek medical attention.
Inhalation: Remove to fresh air. Seek medical attention
immediately. If breathing stops give artificial respiration.
Ingestion: Do not induce vomiting. Seek medical attention
N/A= NOT APPLICABLE · N/E=NOT ESTABLISHED · N/D=NOT DETERMINED · <=LESS THAN ·
NOTICE: The information contained on this Material Safety Data Sheet is considered accurate as of the
date of publication. It is not necessarily all inclusive nor fully adequate in every
circumstance. The suggestions should
not be confused with, nor followed in violation of applicable laws, regulations, rules or insurance requirements. No warranty,
express or implied, of
merchantability, fitness, accuracy of data, or the results to be obtained from the use thereof
is made. The vendor assumes no responsibility for injury or damages resulting from the
inappropriate use of this product.
Protection: Always wear safety glasses or chemical proof goggles when working with any chemical.
IX · SPILL OR LEAK PROTECTION
STEPS TO BE TAKEN IN CASE OF SPILL OR LEAK:
Allow propellant to evaporate. Maintain local exhaust and adequate ventilation. No smoking. Keep sparks, heat sources and
flame far away from spill or leak. Cover with absorbent material and sweep up. Wash area to prevent slipping. Dispose
of soaked absorbent material in accordance with Federal, State
and local laws.
WASTE DISPOSAL METHOD: Aerosol
cans, when emptied and depressurized through normal use, pose no disposal hazard and should be recycled. Consult Federal,
State and local
authorities for approved procedures.
SECTION VIII ·
SPECIAL PROTECTION DATA
Respiratory Protection: None needed for proper use in
accordance with label directions.